NSK 54209 U Ball Bearing (35x78x45)
Description
As a thrust ball bearing, this bearing carries axial loads only and must not be loaded radially. At 35x78x45 mm and a unit weight of 0.784 kg, the installation envelope is fixed; further technical details are held in the specification table. The balls run here between two flat washers in standard bearing steel, which are fitted separately and only brought together during installation.
The thrust ball bearing transmits force through balls between two flat washers and is therefore restricted to longitudinal loads; radial load must not be placed on this bearing but belongs at a separate radial bearing position. The set is separable, so the shaft washer and the housing washer can be fitted independently and handled individually during repair.
For the balls to roll rather than slide under all operating conditions, a permanently acting minimum axial force is required; without it at high speed, centrifugal force prevails and rolling contact is lost. The seating faces must be square to the shaft axis, because any out-of-square condition concentrates the load onto a few balls. Standard bearing steel is through-hardened and provides the raceway hardness and dimensional stability for the usual operating-temperature range; for the design, axial force, speed and the required minimum load should be assessed together.
NSK 54209 U Kugellager (35x78x45)
— 35 x 78 x 45 mm
Response within 4 business hours
Same size — other brands
Bearings of the same type with identical dimensions 35 × 78 × 45 mm — please check sealing, clearance and execution.
multiple variants for this number — please select
This designation exists in several variants. Please pick the matching one.