NSK 627 ZZMC5E Kugellager (7x22x7)

This NSK bearing measures 7x22x7 mm and weighs 0.012 kg; the specification table carries the supplementary technical details. This variant features increased radial clearance (C3). The deep groove ball bearing is the most widely built rolling bearing type, and the reason is how little it asks: it carries radial load, supports moderate axial load in both directions, and demands little of the surrounding design.

The deep, closely conforming raceway grooves in the inner and outer ring capture the balls positively, so the bearing takes radial load and moderate axial load in both directions without a second bearing position to oppose it. Because the ball touches the raceway at a point, friction and heat stay low — the precondition for high speeds and for grease-for-life designs.

The limits follow from that same geometry: the small contact area caps load capacity against a roller bearing of equal size, and the bearing tolerates misalignment within narrow limits only, since angular error transfers straight into the raceway grooves. Seats in shaft and housing must therefore be aligned and geometrically accurate; where shaft deflection is expected, a self-aligning type belongs in that position.

The shields on both sides run without contact: they hold back coarse contamination and keep the lubricant in, adding no frictional torque — but they do not protect against splash water or fine dust. Rings and rolling elements are made of through-hardened standard bearing steel. The slightly increased radial clearance provides reserve for tighter fits and for temperature differences between inner and outer ring, as they occur on shafts that run warm.