SKF NU330 ECM/C4VA301 Zylinderrollenlager (150x320x65)

As a cylindrical roller bearing, this bearing carries high radial loads with limited axial capacity. At 150x320x65 mm and a unit weight of 26.3 kg, the installation envelope is fixed; further technical details are held in the specification table. This variant features greatly increased radial clearance (C4). Where both rings are fitted tight, or the shaft runs permanently and appreciably warmer than the housing, a standard clearance no longer suffices on paper — that is what this strongly increased clearance (C4) version is meant for.

Strongly increased clearance (C4) does not describe a different bearing but a larger initial radial play for the same rolling geometry. It makes sense wherever the known consumers of play bite particularly hard: with a tight seat on both rings, with an inner ring drawn onto a tapered shaft or a sleeve and deliberately expanded in the process, and with a sustained heat flow from the shaft into the bearing, as occurs on drying cylinders, hot-running fans or in rolling mill arrangements.

In these cases a standard clearance leads on paper to an operating play near zero, and the result would not be a particularly accurate guide but a preloaded roller set with rising frictional torque and rising temperature. Strongly increased clearance (C4) moves the starting point up far enough that a workable residual play remains after fitting and heating.

Its downside is to be seen in the cold, unloaded state: the bearing then runs with noticeable play, the load zone is narrow, and the most heavily loaded roller carries a larger share of the radial force. For the layout this means assessing the operating clearance rather than the mounted clearance, and considering fits, drive-up distance, temperature profile and load direction together in order to do so.

The open form presupposes sealing and lubricant supply by the surrounding construction, which in hot service must also carry part of the heat dissipation.