ZEN S6005-2RS-C3 Kugellager (25x47x12)

The mounting dimensions are 25x47x12 mm and the weight is 0.08 kg; technical details beyond these are shown in the specification table. This variant features a contact seal and stainless steel and increased radial clearance (C3). Point contact between ball and raceway keeps frictional torque low, which is why this type runs faster and cooler than any other rolling bearing.

The deep, closely conforming raceway grooves in the inner and outer ring capture the balls positively, so the bearing takes radial load and moderate axial load in both directions without a second bearing position to oppose it. Because the ball touches the raceway at a point, friction and heat stay low — the precondition for high speeds and for grease-for-life designs.

The limits follow from that same geometry: the small contact area caps load capacity against a roller bearing of equal size, and the bearing tolerates misalignment within narrow limits only, since angular error transfers straight into the raceway grooves. Seats in shaft and housing must therefore be aligned and geometrically accurate; where shaft deflection is expected, a self-aligning type belongs in that position.

The contact seal bears against its counterface and closes the rolling chamber against dust, splash water and wash-out; in return it raises frictional torque and limits permissible speed. The stainless steel version is intended for damp, wet or chemically loaded surroundings and for applications demanding freedom from rust; its load ratings sit somewhat below those of standard bearing steel.

The slightly increased radial clearance provides reserve for tighter fits and for temperature differences between inner and outer ring, as they occur on shafts that run warm. Increased radial clearance C3 — Dimensional/form-fit equivalent — verify suffix-level details for critical applications. Matching suffixes are also listed by SKF (HC5C3, HC5C3WT, C3), FAG (C3), NSK (C3), NTN (C3) and NACHI (C3).