Skip to main content
Euro Bearing
4.8 Google & eBay · 36,000+ items in our range · usually ships in 1–2 days · Purchase on invoice for businesses · Free shipping from €100
Knowledge · Mounting

Mounting insert bearings correctly

Locking methods, mounting sequence and tightening torques for housed bearing units — and the mistakes that ruin shafts and bearings.

Locking methods at a glance

SystemPrincipleCharacteristics
Set screws (UC series)Two grub screws offset by 120° in the extended inner ring clamp the shaft.Standard; both directions of rotation; drawn shafting sufficient
Eccentric locking collar (SA/UEL)Eccentric collar is tightened in the direction of shaft rotation and secured with a grub screw.ONE direction of rotation only; self-tightening; low vibration
Adapter sleeve (UK series)Tapered sleeve tensioned with a lock nut — concentric, firm seat.Best runout; higher loads; easy dismounting
Cylindrical boreClassic interference seat as with a deep groove ball bearing.Precise location; machined shaft seat required

Mounting step by step

1Prepare the shaftCheck shaft for size, runout and burrs; clean the seat and oil lightly. On used shafts, dress the marks of previous set screws — otherwise the unit will not slide.
2Slide on and alignBolt the housing on stress-free (bolts finger-tight), insert the shaft, align both bearing positions, then tighten the housing bolts. The spherical seat compensates static misalignment only — it is no substitute for alignment.
3Tighten the set screwsSeat both screws lightly first, then tighten alternately to the manufacturer torque. Never fully tighten one screw before the second one seats — the shaft would be clamped off-centre.
4Eccentric collar (if fitted)Tighten the collar by hand in the direction of shaft rotation, set it with a drift or hook wrench, then tighten the grub screw in the collar. Mounted against the rotation it will loosen in service.
5Re-tighten after a test runAfter a short run under load, recheck screws and bolts to torque — settling on drawn shafting is normal. Use medium-strength threadlocker in vibrating applications.

Tightening torques

Tightening torques for set screws and eccentric collars are manufacturer-specific: they depend on thread size, screw design and inner-ring material, and are stated in the manufacturer’s data sheet or mounting instructions. Generic bolt torque tables (e.g. for grade 8.8 bolts) must not be used — they are far above the permissible values and damage thread and shaft.

For every housed unit ordered from us we provide the manufacturer values for your size on request — email info@eurobearing.de or use the contact form.

Typical mistakes

The most frequent failure causes on housed bearings are avoidable: unevenly tightened set screws (shaft runs eccentric), eccentric collars mounted against rotation (they loosen), no re-tightening after run-in, hammer blows on housing or inner ring, and reusing shafts with worked-in clamping marks and fretting. Recurring loosening usually indicates an undersized shaft or damaged clamping point rather than insufficient torque.